Handheld Laser Welder Building Material Shops Laser Welder Fiber Joint Welding Machine

HANDHELD FIBER LASER WELDING MACHINE

Introduction:

It is preliminarily understood that most of the stainless steel products are used in the manufacturing process by argon arc welding and other common welding methods, which can meet the requirements of 80% of the production, but will leave the defects in many welding products. For example, undercut, incomplete penetration, dense pores and cracks not only reduce the robustness of the joint but also become a source of corrosion for crevice corrosion. In the process of welding, not only the welding technology of the welder has a certain level, but also the welding skill and the cost requirement of the welding flux are too large, and the cost required for production can be improved. And the working step of processing is also carried out after welding, and the time efficiency is very slow. Because of the existence of these defects, the hand-held fiber laser welding machine is born.

Features:

1. 10 times energy efficiency rate, electro-optic conversion efficiency > 30%;

2. High ratio of deep-width, small weld width, small heat affected zone, small deformation and fast welding speed.

3. The weld joint is smooth and beautiful, and there is no need to deal with it or just a simple treatment process after welding.

4. It is especially suitable for ultra-thin welding which can not be welded by argon arc welding.

5. Volume: compact size, built-in water cooling, hand-held welding flexible and convenient, can achieve outdoor welding;

6. Maintenance: no adjustment, low energy consumption, no consumables, long-term use can save users a lot of processing costs;

7. Using humanized safety protection design, welding gun can not output laser without contact with metal, and put an end to safety accidents caused by misoperation.

Fiber Laser Welding Machine PD-F1000CW Technical Parameters

Payment

• We accept T/T, if buyers have any problems about payment, please contact us ASAP.

Shipping

• 7 working days after payment.
• Tracking No. will be sent to you after delivery, and you will get every important shipping status by email.
• By sea

• Inquiry and consulting support.
• Sample testing support.
• Visiting our factory.

After-sales services

• Engineers available to service machinery overseas. and consulting support.
• Training how to install and use the equipment.
• Free parts.

PD-F1000CW Installation requirements

Please install this equipment in a solid horizontal and non-inclined place. The input voltage of the equipment is single phase 200-240VAC 50/60 HZ capacity above 40A ±10%. The equipment must be grounded. Please install this equipment in the surrounding temperature 5~40 oC, humidity below 85%, no drastic temperature change. In addition, please avoid using: Places prone to dew; Places with many vibrations and shocks; Places in high frequency sources of interference; Places with large amounts of garbage, dust and oil; The parts and walls of the equipment should be kept above 60cm for ventilation and heat dissipation. Cooling water (distilled water or drinking pure water) is required for the new machine. Add cooling water into the cooling system tank to the water level line, then, cover the water temperature set to 25 ℃ (winter) -28 ℃ (summer); For new machines and machines that have just replaced laser tubes or cooling water, turn on the air switch and wait for the water cooler to run for five minutes, allowing the water cooling system to discharge all blisters. And check whether the pressure of the water chiller hydraulic meter is normal if shut down several times to restart the exhaust air.